Hobbico Hadron Informations techniques télécharger pdf (Page 3)

ASSEMBLY

Program Your Transmitter

1. Remove the turtledeck and set aside.

Motor

rotates

right

Rudder servo

arm rotates

counter-

clockwise

Motor turns clockwise

Both elevons up

Left elevon down Right elevon up

2. Connect the servos and ESC to your receiver and power up the system with a battery so you can operate the servos and motor

(if not done so already, this may also require linking the receiver to your transmitter). Program your transmitter and connect the

servos to the receiver so the controls respond correctly to stick movements—if using the TTX650 simply follow the programming

instructions and connect the servos into the receiver as instructed on page 11. Note: If the ESC beeps continuously and

you cannot get the servos to respond, the ESC requires calibration to detect the throttle stick endpoints. Follow the Throttle

Calibration procedure on page 13.

IMPORTANT!: If using a Tactic radio, be certain to link the receiver to the transmitter after the throttle channel has been

reversed. Otherwise, the motor will switch to full-throttle when signal is lost (i.e., if the transmitter is accidentally turned off

before disconnecting the battery from the ESC).

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Hobbico Hadron Informations techniques Page 3