Hobbico Hadron Informations techniques télécharger pdf (Page 15)

REPAIRS

AeroCell foam is easily reparable. Pliable glue such as canopy

glue is the very best, but requires tape to hold the parts together

while the glue dries overnight. CA is usually the go-to adhesive

for repairing AeroCell and with a little CA accelerator the repair

will be complete in minutes. For a seamless repair excess CA

may be removed from the surfaces with CA debonder (debonder

will affect the decals and paint).

MOTOR REMOVAL

If you ever have to remove the motor, the top and bottom

moveable motor mount halves must be separated. This is done

by taking out the top and bottom 4mm pivoting screws, the

four 3mm motor mount screws and ﬁ nally the four self-tapping

screws holding the halves together.

Once the motor comes out with the top moveable mount,

disconnect the motor from the ESC and guide the wires out

through the molded-in retainer.

NOTE: If considering a different motor other than the 35-36-2200

(FLZA6522) included with this kit, make sure the orientation of the

mounting holes will allow the wires to align with the retainer in the

moveable mount. Otherwise, the motor will not ﬁ t.

Motor wires

19mm

16mm

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Hobbico Hadron Informations techniques Page 15